To replace the front park/turn signal lights, disconnect the electrical connector of the bulb holder, then turn the socket counterclockwise to remove it and take out the bulb. To replace the rear tail light, open the trunk, loosen the trunk lining, loosen the electrical connector, loosen the nuts that hold the tail light assembly in place, and remove the tail light assembly out of the rear panel. To change a bulb, turn the bulb holder in an anti-clockwise direction and remove the bulb out of the holder. In the case of the high-mounted brake light, open the trunk, then turn the bulb holder in a counterclockwise direction to lower it out of the housing and remove the bulb. The instrument cluster lights are only accessible by removing the instrument cluster, then the bulbs are replaceable by rotating the bulb holder counterclockwise. In the case of reading lights, older lights (before 1998) need to remove the lens and simply straight out the bulb, whereas later lights (since 1999) need to peel the housing off the headliner and pop the clips to get the bulbs out. To replace the license plate light, open the trunk and tap behind the assembly and turn the bulb holder counter clockwise to eject the bulb. In the case of fog lights, lift the vehicle, unscrew the electrical connector at the back of the bumper and on 1998 and earlier models, unscrew the screws to pull off the fog light, and in 1999 and later models, unscrew the electrical connector and turn the bulb holder to remove it. All the components can be installed in reverse to the removal.