What are the important considerations and procedures for renewing Fog Light Bulb, Headlight Bulb, and other types of bulbs on Mitsubishi Lancer?

Various kinds of bulbs are fitted to the complete range of vehicles and, when renewing a bulb, it is important to use the correct voltage, wattage and type. Typically, the voltage and wattage are stamped on the bulb base or glass. A bulb that is marked 12v/21w, for example, is a 12-volt and 21-watt bulb. A dual filament bulb used in stop/tail lamps. It is actually two bulbs in one base. For example, a marking of 12v 21/5 means that the bulb has a wattage of 21w for the stop filament and 5w for the tail filament. To test bulbs, remove them from the holder and connect jumper leads to the battery. If illuminated, the bulb is fine but otherwise should be replaced. To renew the headlamp bulb, disconnect the wiring, take off the dust cap, unclip the retaining clip, and pull out the bulb without touching the glass. The bulb is secured, and the headlamp is checked. To renew the bulb of the fog lamp, remove the lamp, withdraw the bulb and check the proper sealing ring seating. To adjust the headlamp and fog lamp aim, park the vehicle over level ground and unladed condition. Then use the aiming equipment or a board to mark reference lines and adjust the beams as per the local regulations. Various lamps such as front park, turn signal, side turn signal, rear combination, high mounted stop, number plate, reverse and courtesy lamp have generally pretty similar and straightforward procedures to take out wiring and covers and ensure contacts are clean. After that, you can install a new bulb.

Genuine Mitsubishi Lancer Fog Light Bulb

Fog Lamp Bulb

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

5 Fog Light Bulbs found

View related parts
Mitsubishi Lancer Headlamp Bulb Part Number: AB009006
$7.71 MSRP: $10.03
You Save: $2.32 (24%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Bulb, 12V-51W, 9004-HB4; Fog Light Bulb; Headlight Bulb; Car Bulbs; Fog Lamp Bulb; Lower Beam Bulb; High Beam Bulb; Bulb
- Warranty: This genuine part is guaranteed by Mitsubishi's factory warranty.
Fits the following Vehicles:
- 2010-2015, 2008, 2004-2006 Mitsubishi Lancer | Evolution, Evolution GSR, Evolution MR, Evolution MR Touring, Evolution RS, Evolution SE | 4 Cyl 2.0 L GAS
View related parts
Mitsubishi Lancer Lower Beam Bulb Part Number: MS820949
$17.29 MSRP: $22.52
You Save: $5.23 (24%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Bulb, Lamp, 12V-27W; Fog Light Bulb; Headlight Bulb; Car Bulbs; Fog Lamp Bulb; High Beam Bulb; Headlamp Bulb
- Warranty: This genuine part is guaranteed by Mitsubishi's factory warranty.
Fits the following Vehicles:
- 2008-2016 Mitsubishi Lancer | DE, ES, ES Sportback, Evolution GSR, Evolution MR, Evolution MR Touring, Evolution SE, GT, GT Sportback, GTS, GTS Sportback, Ralliart, Ralliart Sportback, SE, SEL | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS
View related parts
Mitsubishi Lancer Fog Lamp Bulb Part Number: MS820964
$19.23 MSRP: $25.03
You Save: $5.80 (24%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Bulb, Front Fog Lamp; Fog Light Bulb; Car Bulbs; Bulb & Socket; Bulb
- Warranty: This genuine part is guaranteed by Mitsubishi's factory warranty.
Fits the following Vehicles:
- 2004-2006 Mitsubishi Lancer | Ralliart, Sportback, Sportback Ralliart | 4 Cyl 2.4 L GAS
View related parts
Mitsubishi Lancer Fog Lamp Bulb Part Number: MS820984
$31.76 MSRP: $41.35
You Save: $9.59 (24%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Bulb, Front Fog Lamp, Halogen; Fog Light Bulb; Car Bulbs
- Warranty: This genuine part is guaranteed by Mitsubishi's factory warranty.
Fits the following Vehicles:
- 2016-2017 Mitsubishi Lancer | ES, GT, SE, SEL | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS
View related parts
Mitsubishi Lancer Fog Lamp Bulb Part Number: MS820976
$25.32 MSRP: $32.07
You Save: $6.75 (22%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Bulb, Lamp, Halogen, 12V-5; Fog Light Bulb; Headlight Bulb; Car Bulbs; Lower Beam Bulb; Bulb & Socket; Headlamp Bulb
- Warranty: This genuine part is guaranteed by Mitsubishi's factory warranty.
Fits the following Vehicles:
- 2008-2016, 2003-2006 Mitsubishi Lancer | DE, ES, ES Sportback, Evolution, Evolution GSR, Evolution MR, Evolution MR Touring, Evolution RS, Evolution SE, GT, GT Sportback, GTS, GTS Sportback, Ralliart, Ralliart Sportback, SE, SEL | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS

Mitsubishi Lancer Fog Light Bulb

The Mitsubishi Lancer Fog Light Bulb's design allows it to project a low beam that is wide and aimed towards the road surface so that drivers can see more clearly during fog, heavy rain, and snow. Because the bulb is mounted low on the vehicle, its light penetrates the moisture that reflects the usual headlight beams back. This function reduces glare and helps with visibility. Because of the position and beam pattern, the driver can see lane markings, edges of the road, and obstacles. Like the original equipment, the component uses halogen technology. Halogen bulbs offer a longer service life compared to older, conventional incandescent designs. However, as the filament still dims, pairwise replacement is recommended to maintain illumination. Apart from the regular halogen variant, a Mitsubishi Lancer owner can either opt for more powerful halogen bulbs or choose the LED version that boasts longer durability, all of which fit into the same bulb holder without modification. All Fog Light Bulb styles activate their power upon switching the fog light and help preserve service life until poor weather conditions arise. It is advisable to carry a spare Fog Light Bulb to be able to replace any faulty one during a trip to the hills or other coastal areas. Failure of such a bulb can impede the vehicle's lighting during a critical moment. Equipping the Mitsubishi Lancer with new and working Fog Light Bulb ensures a level of safety for the motorist when visibility decreases. In short, the low-mounted lamp that is specialized for this and which complements the primary headlights and the regular maintenance of the Mitsubishi Lancer lighting system helps in maintaining the ability to pierce challenging conditions.

OEM Fog Light Bulb can boast superior quality and long-term durability. Each part meets strict factory specs and passes careful checks in production. So you'll get Fog Light Bulb with long-lasting strength and an exact fit. If you need OEM Mitsubishi Lancer Fog Light Bulb, the online store is the ideal place. The store carry a wide range of genuine Mitsubishi Lancer parts at the highly competitive prices. You'll enjoy a simple and no-hassle shopping experience. You'll get unbeatable prices and fast delivery service. You'll get the manufacturer's warranty and a straightforward return policy. Shop with confidence and keep your car in top condition.

Mitsubishi Lancer Fog Light Bulb Parts Questions & Experts Answers

Headlamp Bulb
AB009006
Q: What are the important considerations and procedures for renewing Fog Light Bulb, Headlight Bulb, and other types of bulbs on Mitsubishi Lancer?
A:
Various kinds of bulbs are fitted to the complete range of vehicles and, when renewing a bulb, it is important to use the correct voltage, wattage and type. Typically, the voltage and wattage are stamped on the bulb base or glass. A bulb that is marked 12v/21w, for example, is a 12-volt and 21-watt bulb. A dual filament bulb used in stop/tail lamps. It is actually two bulbs in one base. For example, a marking of 12v 21/5 means that the bulb has a wattage of 21w for the stop filament and 5w for the tail filament. To test bulbs, remove them from the holder and connect jumper leads to the battery. If illuminated, the bulb is fine but otherwise should be replaced. To renew the headlamp bulb, disconnect the wiring, take off the dust cap, unclip the retaining clip, and pull out the bulb without touching the glass. The bulb is secured, and the headlamp is checked. To renew the bulb of the fog lamp, remove the lamp, withdraw the bulb and check the proper sealing ring seating. To adjust the headlamp and fog lamp aim, park the vehicle over level ground and unladed condition. Then use the aiming equipment or a board to mark reference lines and adjust the beams as per the local regulations. Various lamps such as front park, turn signal, side turn signal, rear combination, high mounted stop, number plate, reverse and courtesy lamp have generally pretty similar and straightforward procedures to take out wiring and covers and ensure contacts are clean. After that, you can install a new bulb.