Switches

1999 Mitsubishi Diamante Door Jamb Switch, Neutral Safety Switch, Turn Signal Switch

Currently shopping for

1999 Mitsubishi Diamante

Change Vehicle

Vehicle Options

Base; 6 Cyl 3.5 L GAS

Vehicle Options

Base; 6 Cyl 3.5 L GAS

Categories Close X

Currently selected

Electrical

Other Categories

A/C & Heating

Air & Fuel Delivery

Belts & Cooling

Body & Hardware

Brakes

Charging & Starting

Driveline & Axles

Emission Control & Exhaust

Engine

Headlights & Lighting

Interior & Exterior Trim

Maintenance & Lubrication

Steering

Suspension

Transmission

How to use OE catalog

4 diagrams found. Select a diagram to view its particular parts.

1.Front Door - Interior Trim
2.Instrument Panel - Instrument Panel Components
3.Rear Door - Interior Trim
4.Steering Column - Shroud, Switches & Levers

Sort by:

Ref No.

Part No. & Part Description

Price & Qty.

Part No. &
Part Description

2
MB903639
Ignition Switch
- Part Notes: Switches & Display Unit
$68.94 $49.63
1
Add To Cart

2
MB608104
Trim Panel Assembly Clip
- Location: Driver Side;Passenger Side
$2.47 $1.89
1
Add To Cart

5
MS480009
Trim Panel Assembly Grommet
- Location: Driver Side;Passenger Side
$2.75 $2.11
2
Add To Cart

8604A011
Neutral Safety Switch
- Part Notes: Diamante
$125.82 $90.59
1
Add To Cart
8614A183
Stoplamp Switch
- Part Notes: Diamante
$38.78 $29.79
1
Add To Cart

OEM 1999 Mitsubishi Diamante Parts for Switches

The OEM parts are ultimately desired quality-wise. The Switches components are produced by Mitsubishi, manufacture according to factory guidelines and during production they undergo quality testing. In case you require new OEM 1999 Mitsubishi Diamante parts then you can view our entire catalogue. All of our genuine OEM 1999 Mitsubishi Diamante Door Jamb Switch, Neutral Safety Switch, Turn Signal Switch are sold at a low price and are supported by a warranty of the manufacturer. In addition, we provide quick delivery and easy return policy to provide a good experience. No longer wait and do shopping with us!

Brake Light Switch Installation and Repair Tips for 1999 Mitsubishi Diamante

Q: How to remove and install the brake light switch on 1999 Mitsubishi Diamante?
A: Disconnect negative battery and unplug stop lamp switch connector. Unscrew locknut, loosen switch, screw in new switch and tighten locknut. Adjust set case-to-pedal gap to 0.0204 in (0.5-1.0 mm) so that as plunger is released, the pedal is actuated. Install reconnect wiring, position ignition ON and test: after free play, adjust to eliminate flicker.

See All Installation and Repair Tips